You did a good job – I like the final Holder!
-- Michal, http://WoodworkingWeb.com
Very cool project. The curves on the sides and shelves gives it a graceful look.
-nicky
Very nice….I’m with you simple but elegant.
Mike
Mike
A good way to deal with runs in finish is to take a a sharp chisel, lay it flat against the piece and slice the drip off flush to the surface, then a light sand with fine abrasive. That way you won’t create a halo around any high spots when you are sanding. I believe auto finishing shops have a special tool for doing the same thing.
Nice job, I’m sure your daughter will be delighted.
Doing the best I can with what I've got
Rennner:
Thanks – I went half-way through your recommended procedure – and would have been much better served if I had your experience during-the-build. I’ll follow your advice in subsequent builds.
MJCD
I like this design.
woodworking classes, custom furniture maker