jig

Fresh on the heels of my mitre sled comes this spline jig for box corners.

Last jig for a while. I promise. I made a finger joint jig today. This one is for 1/2" joints. I started by making the key. That took about 20 pass...

This one came from a discussion in lanwater"s blog about hammer veneering. The topic of safe straightedges for knifework came up and a few ideas we...

Since this seems to be the week for jigs, here’s one I made recently for corner keys in boxes and frames. There’s nothing fancy about it but it doe...

A riggedy-jig and away we go … Woodworkers do love their jigs and if they don’t, they probably just haven’t tried one yet. So many uses and so many...

Been busy in the “Wood Shop,” putting together table saw sleds and router jigs. It’s great to be back in woodworking. Didn’t realize that I missed ...

For the wheel grooves I needed a jig. Used my tractor wheel jig and made a little expansion. The pieces A,B and C are from the tractor wheel jig. P...

MaFe hand jointer for small parts. The other day I were buying some tools from the fine-tools.com, I saw Veritas had made a jig, that made it possi...

 Before starting to cut the pyramid segments, I cut/built some templates from the second half of the maple board I resawed and planed for the pyram...

 I wanted to use glue to attach the pyramids to the disks, because I didn't want any visible fasteners. But it was very apparent that I would need ...

Before I could start drilling the dowel holes in the part faces, I had to make the angle-specific drill guide blocks I mentioned in a previous post...