ukulele

I found this article in the Spring 2023 issue (number 148) of American Lutherie. According to the article, this is an instrument that was one of th...

The soundboard is Master Grade Sitka Spruce. Came in rough at about 3/16" thick. I glued the book matched halves together the cut out the oversized...

Jig Setup I set up the assembly fixture using the body template, and fixed the neck position.  [IMG_2612.jpeg][IMG_2613.jpeg] Check the Side Fit ...

Back panel glued-up and trimmed flush to the sides. [IMG_2634.jpeg][IMG_2635.jpeg][IMG_2637.jpeg] Installed soundboard lining and sanded flush to t...

The design for this project is mostly complete. Just need to add the action layout to the setup layer but that can wait until much later. I got a r...

Installed the linings for the back panel and sanded flush to the sides. Laser cut the back panel and all the braces. When I get my 120 grit sand pa...

Fitted the braces and reinforcing ring to the inside of the soundboard. [IMG_2648.jpeg][IMG_2650.jpeg] Fitted the soundboard to the body. I suppose...

Taking care of the other details now that the main assembly is complete. Added the binding at the soundboard. Started out as 1 x 5mm Black Walnut. ...