Vises

Shamelessly copying bits from Eric's high vise, I decided to build something reasonably similar.  I'm planning on building 2, this mini one that si...

So, first thing to do is chisel the slot in the right chop. [20230826_100040.jpg] And that's about all that's needed for a working vise. [20230826_...

Not going to do too much to it, just a couple of finishing touches. Round over the guide nut & make a new, slightly longer, garter - round the end...

Well, I've used it for a couple of weeks, made some stuff, tested it, hit it with little hammers - the usual stuff. [20230902_110347.jpg] I like i...

Onto the full size Hi Vise First up, make the main screw, basically make a rough octagon. [20230906_073418.jpg] [20230906_073724.jpg] [20230907_12...

I'm making the body out of an ash 2x4. so cut to size and square up. [20230915_162313.jpg] [20230915_163836.jpg] Drill and tap the main hole [20230...

Make the handles for the fixing screws.  [20231001_160522.jpg] [20231001_161419.jpg] Just rasp into shape and add a bit of walnut to the end to hi...