re: Blanket chest

I haven't found my favorite way to do dovetails yet. Right now I am using a combination of power tools and hand tools. I don't like using a router. I don't like the look of dovetails when the pins and tails are the same size and I feel like there is so much strain on the bit when pushing it through stock. I also worry about tear out. My least favorite part of hand cut dovetails is chiseling the tails. So right now I use the table saw to cut the tails. I have a blade that has been ground to 10 degrees. With it you can make a fairly skinny pin and the blade cleans out the corners of the tails. I then use a chisel to get what little is left between the tails. I then lay the tail board on the pin board the traditional way. 
I hope that make sense.

Pottz, I would love  to do that if there is an easy way, thanks.