re: Workbench/ Outfeed #2

Im on a hold till I can figure out what happened to my last critical dimension for the carcase’s. Im totally puzzled. I seriously quadruple checked all my dimensions. Checked for square took my dimensions and made my last carcase. And you’d think it would fit. Aaaaa no. Checked that box out right dimensions and square. Now I even pulled out a machinist square everthing is square. Im taking a breather so I can clear my mind and im going to clean up an area and what I am going to do is level the bench as if it were done what I want to see if im getting deflection in the total length because everthing is square where I check but when the last cabinet goes in im showing 1/8" of vertical out of plumb next to the face of my 36" cabinet at the face edge. I hope im not confusing you. However what im trying to say is if the center is sagging the ends will tip in at the highest point of your end dimension still leaving other things square. That means a few more supports underneath before I go any further. So ill be getting back to you guys when I figure out what happened. A little knot in the log. Lol