Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Thanks everyone!
Fun to make, BUT even with the outer dimensions all within 0.010", fitting each lid was a pain in the gitalong.
A few thousandths was the difference between lid not fitting or lid falling off. I did put a slight taper into the rabbet, but setup for the first one ended up too small (lid falls off). Had to add a layer of veneer and then sand that back.
Fun to make, BUT even with the outer dimensions all within 0.010", fitting each lid was a pain in the gitalong.
A few thousandths was the difference between lid not fitting or lid falling off. I did put a slight taper into the rabbet, but setup for the first one ended up too small (lid falls off). Had to add a layer of veneer and then sand that back.
