Center section half done, front section started, time for the rear section. It's just solid 5" rings with a 1/4" hole in the center. I made a jig to cut the dado whatever for the horizontal stabilizer. Almost same same as the cut for the wing in the center section, except this is on the end. And a dado groove for the tail/rudder. Plus, cutting the assembly in half at a 45 degree angle. There was a long piece of 1/4" x 20 threaded rod to glue the rings together. I made the jig fit the bs table real good. It worked like a charm.
It would have been better if I cut the groove for the tail first. It worked out. Still a bummer... It's starting to look like something.
Hey, you don't know me, but you don't like me ... Buck Owens
