maple

I wanted to make some hexagon boxes again, this time using thinner stock. Started out with some rough cut 4/4 Pecan and Maple about 8" wide and 8' ...

Finished fitting the drawer panels and glued up the drawers. [20230303_115133.jpg] [20230303_121802.jpg] Sanded the proud fingers on the disk s...

Been a little slow on progress, yard work has been getting in the way. Had a few of the finger joints that were a bit off, so with chisel in hand,...

Moving along to the top and bottom, had to surface a edge join a couple of pieces, to glue up for the width I needed. Used the Moxon bench top with...

Back at it again, I finished the inside of the case along with the interior surfaces of the top and bottom. I taped off the edge where the glue li...

Well I’m at it, the one part of this build that I wasn’t 100% confident in. I started the glue up with two sides and the 8 straightest boards to gi...

I found some hardwood at a local lumber middleman, none of our mills have any type right now and might not until spring. I even had to order this b...

Just a quick post of the stretchers dry fit. I still have to add the 2×4 and tension mortise it all in. , As always questions and tips welcome. Tha...

What a horrible picture! I’m sure that’s the first thought as you start this blog. I’m sure it was followed by things like: did he use a flip phone...

With the legs already cut to length its time to glue them up. I have the joinery drawn out on the top roughly so that after cutting the boards the ...

I have just finished drilling the pilot dog holes into the top boards that I have vises for. This will allow me to have a nice straight batch of do...

I received the crisscross from Lee Valley late yesterday, and started mocking it up to see what needs to be done. I glued up the last piece of the ...