re: New Jointer

Tony,
The jointer looks good, especially because of the fact its 2nd hand and has been kept in such good condition.
I have to agree with you the fence certainly attracts attention and considering the length of it even more so.

A jointer has to be one of the least used tools but essential in a workshop for flattening material.
You can also use it for making rebates and tapers for legs.
It will take quite a good deal of your time and patience when its blade change time to set it up correctly again so beware, again there are lots of video demos on doing this procedure along with and a large variety of “set up” tools available.
You will learn about Magnetic Micrometer gauges and so on.
All which are expensive and do a great job, however once you become confident in what you are doing you can do the same with a simple straight edge and obtain the same results.

Buy a good in position diamond Blade hone as it will reduce the amount of times you will need to remove the blades.
A second set of blades or more is almost essential, dependent on the work you are doing and if you intend to have the blades resharpened by an outside service.
Again there is heaps of methods available to do the sharpening yourself if you so desire.

Check out all the various functions and give them a try, if you use them all the time so be it, otherwise just remember what the jointer is capable of for later.

Take care with it and dont forget to use push paddles even Sam Malouf fell victim to a Jointer!

enjoy!

P.S. That is a nice car you have!!