Stand it up on edge and make the 1 1/2" cut first on the table saw
If I did that I could then move the fence in 1/8" and repeat twice, and it's done.
1 1/2" high T/S blades scare the snot out of me.
Set the fence so your cutting the outside off not trapping the off cut between the wood and the fence.
Incra fence on a right tilt saw. Biesemeyer would be better sometimes. I know, it don't matter, but it sure is different.
However I do it, it's getting a jig. NO fingers near spinning metal. I'll see what happens with the jointer.
Thanks!!
I want to do right, but not right now. Gillian Welch