Thanks again all for taking the time to read and comment.  You only encourage me, but SWMBO claims I'm worse without encouragement.


 Birdseye49
 commented about 12 hours ago
Now, I have to figure out how to make these with a 10 watt laser.

Or convince the CFO of the need for a more powerful laser. 


Most of the smaller lasers will cut 3mm (MDF/ply)... it's that extra .175 (if using 1/8") they struggle with... go metric!

Cut out of 3mm (x ?) and laminate using dowel alignment... the main problem with that is that mass production may have a tad overhead.  


 Jim Jakosh
...make a lot of them...all the same!!

Thanks JJ. One of my ideas was to hand out these to survivors I knew,


Don't mass produce, but do special runs with monograms on one of the pieces.

If your first cut is too short... Take the second cut from the longer end... LBD