Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Looks good...
I can grid position my job using x/y co-ordinates and place it at 0,0 fort the top engrave and cut. I then flip the board (usually reposition the cut pieces upside down... and try not to throw away the frame beforehand and naturally control the reverse side engrave (without the cut) controlled by software. (FAIW, I use CorelDraw.)
I gave them a few options, but with all the political correctness the department opted not to mention any holiday.
Many call it political correctness... I still think its more BS WOKEdom.
If your first cut is too short... Take the second cut from the longer end... LBD
