Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
re: Ten Wedge Dish
Thank you all for the nice comments.
Hi Bruce, I try to set all the angles at about +0.1 degrees...never minus. On this one it was a little high on the outside edges of the halves and I did not want to send it through the jointer so I pulled out my jointer setup for the spindle sander and took a fuzz off and they were dead flat and I never touched the center.
Cheers, Jim
Hi Bruce, I try to set all the angles at about +0.1 degrees...never minus. On this one it was a little high on the outside edges of the halves and I did not want to send it through the jointer so I pulled out my jointer setup for the spindle sander and took a fuzz off and they were dead flat and I never touched the center.
Cheers, Jim
Cheers, Jim ........................ Variety is the spice of life...............Learn something new every day
