Dremel

11
1
Question: I have a model 4300 that I use in a Veritas router jig. It has worked fine until this week. 

Now, the shaft locking button will not depress to lock the shaft to change bits.   

I disassembled the tool and the button is totally free and moves without resistance. I reassemble, tighten the chuck and it works fine. After a couple of minutes, it is again frozen.

I have opened it up about 6 times, lubed it, etc. Every time it works fine for a few minutes.  Every time I change the bit, I have to take it apart to free the shaft lock.

I have carefully examined the button, spring, and its chase and all surfaces are smooth and without any burrs, etc. 

This tool has about 30 minutes total use.  Dremel's customer "service" said the brushes needed to be replaced! 

Anyone have any ideas?

Carey Mitchell

I looked at a parts diagram for the 4300, similar to the model I have.
My lock is sticky like you describe just not that bad. I suppose the torque from tightening/loosening is causing the lock shaft to wedge in a bit at a slight angle. I sometimes have to wiggle the shaft some (by grabbing the bit) to get it to pop out. I'm sure you've tired that, but it's all I can think of.