CELLPHONE/PEN HOLDER

712
5
One hughe order...
Of 52x210x300 mm oak board, after planing,  I cut 48x60mm laths and cut them on mitersaw to 31cm lenght . Than I made groove 16mm wide, 35mm deep on routertable. Back to mitersaw, cut one side 22 degree angled.
All 14mm holes were made on drillpress, than cut the rest on bandsaw.
Finaly, I sanded all and round edges on routertable. No finish. 

...woodicted

Looks good

Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".

nice simple project, i hope you made some good profit ?

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

Cool and simple!! Nice work, Ivan

Cheers, Jim ........................ Variety is the spice of life...............Learn something new every day


The what can be informative... the how is priceless

If your first cut is too short... Take the second cut from the longer end... LBD

Sharp idea may have to try making one. Good job !!!