STAND - TABLE SIGN

794
7
Wooden stand-table sign, made of beech, 10x7x3cm. Triangle shape I made by cutting one rectangular block on bandsaw with angled table. After that , I equalize both triangle sizes  by cutting short side on tablesaw with specific measured angled of blade. Letters were laser engraved. Finish wood oil.

...woodicted

nice signs ivan, but that last cut on the tablesaw makes me nervous ! i think i would have done those cuts with long pieces then cut them to length. be careful my friend.

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

Nice looking signs.  

Ron



Is that played on an open court or an enclosed room?

If your first cut is too short... Take the second cut from the longer end... LBD

Nicely done

Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".

Thanks Pottz ...I agree but don't wory...Looks dangerous but at the same time not so difficult.
LBD - it is a special kind - enclosed ....hehehe

...woodicted

Nice work, Ivan. I agree with Pottzy on cutting a long piece rather than short pieces.

Cheers, JIm

Cheers, Jim ........................ Variety is the spice of life...............Learn something new every day

I like that idea, good job.