Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Yhprum
13 posts
and
0 followers
in 10 months
in 10 months
More from Yhprum
iPad stand
Made this from an unidentified Australian hardwood for the missus.
15 Comments
Nice and very useful!
Nice job!
simple, well done, and useful, how does it get better ? thanks for sharing.
working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.
Nicely done. What angle did you use? Looks to be in a perfect position.
Nice, something I need to make. Also interested in what that angle is, looks right. Not sure if my Apple is rotten, but if it isn't at a good angle for me, it's hard to see the screen.
so whats an ipad ? 😁
working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.
Thanks for the kind comments! The angle of the cut is 55 degrees, the width of the slot is 10mm or 3/8”. With the iPad screen being at 60 degrees.
Oh, and the general dimensions are 9.75” x 3.625” x 1.75”
Is it finished with anything?
Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".
Finished in gloss spray poly
Thank you!
Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".
looks good, works good. well done
Ron
Also a 👍 for the simplicity!
Does it keep steady when the iPad is in portrait position?
Does it keep steady when the iPad is in portrait position?
Thanks for the details. I see one made soon for my I Pad. I've not used it much because laying flat on a table my neck huts staring down at it, this would be optimal.
It works fine in portrait position. I made a previous version from pine that was quite a bit lighter, the xtra weight of the hardwood makes it steadier.
More from Yhprum
