Wegner Dolphin Chair

[spongebob 4 years later.jpg] It's been 4 years since I built the 1:6 scale model of the "Dolphin" chair by Hans Wegner.   Back then, I didn't hav...

The original design had a notch on the front leg under the seat that was a stop for the folding chair.   Since that notch would serve no purpose in...

Last year I got a good deal on Marketplace for an assorted stack of white oak planks.  I used some of it on the hot tub chair, and will use it on t...

I'm no stranger to using router templates for flush trimming, but I white-knuckled it with these chair parts.  The long curves meant the grain dire...

I was out of town for a few weeks, and wasn't able to be in the workshop.   But I was able to brush up on my Fusion skills and start modeling the f...

For all the mortise and tenon joints between the sides and stretchers, I decided to go with integral tenons cut on the Pantorouter.    Unfortunatel...

I'm focusing on the seat components first so I can work out any kinks in the M/T process.  The components that form seat sides have a single mortis...