The build process starts with the center panel. The substrate is ¼” Baltic Birch or Russian Birch – depending on what I can find. After the center panel blank is cut to size, I work on adding the veneer layer. There are 4 pieces that meet in miters at the center. I put layout lines on the panel to locate the veneer pieces. A piece of plywood acts as a clamping caul. I make sure the tip lines up with the centerlines and is parallel to the edges. I clamp some alignment blocks on each side to keep the veneer from slipping during the clamp up, The notches in the plywood allow my clamp to reach the center.
I use a reference block to make sure the mitered edges are lined up.
The process continues for each piece until the last one is set. I use a clamp to pull the final piece into place and ensure a tight joint.
The panel is now ready for the CNC.
First is the ¼” bit profile.
And then follow up with the 1/16” bit.
Now I can move on to the pieces for the frame. The previous entry showed how I set up to cut the 6 pieces for the arms and then 6 pieces for the post.
First I try out a set-up part. I’m choosing to cut parts for just one side of the arm.
Once I am comfortable I cut out both sets of parts. There is a good deal of hand work need to smooth the parts, adjust the fits, and match the parts at the interface.
I glue and clamp a couple pieces at a time. Then I work on the fitting the adjacent ones.
You can see I mask off the inside corners to better manage any glue squeeze out.
After this I can work on sanding all the surfaces and getting ready for finish.