3D Crosses #5: Confession

8
0

This is part 5 in a 5 part series: 3D Crosses

As with any build not everything goes perfect. Here are a few of the challenges for this build.
 
I have been using the CNC for a few years and am still learning. I felt I had to use too much force to get the collet open when changing bits. I tried locking the collet in with less force and that seemed to help.
 
Until…
 
The bit started to slip out of the collet. It fell through the piece and into the spoil board. I think I now know why it’s called a “spoil board”! Luckily the bit misses the bolt for the spoil board.


The bit started to drop during the previous cut for the plywood reference surface. This ruins the part.


Another “fun adventure” started with cutting the groove for a string insert. I had the bit in the wrong location and started to cut. I make the first pass a 0.020” deep to limit any chip out. I choose to sand the veneer down a bit and continue.
All is well until I am leveling out the final assembly. All the frame pieces don’t necessarily line up well and I use the thickness sander to get everything cleaned up.
 
Normally that works fine…


The earlier thinning of the veneer plus the second thinning was too much. I had to set this aside for a few days to come up with a salvage plan.
 
With a set of locations I did my best to get the piece accurately located back on the CNC bed. I used 2 screws in the middle of the veneer field.


I then cut a profile with the 1/16” bit. I set the profile 1/32” smaller than the inside to the string trim.


The cut was spot on top to bottom but shifted slightly left. I was up against the border trim (ash in this case) with just a little of the center panel exposed on the right. I shifted my zero and cleaned the area nicely.
 
I then cut a pocket for the rest of the center panel. I stayed away from the two clamping screws. Then I added 2 screws in the arms so I could remove the original screws.


At last I can finish the pocket.


Meanwhile, I am building up new lacewood inserts for the center panel. I have only a few pieces left so I have to get creative.


I’ll use 2 of these to repair this cross and the other 2 for a different one.
 
It takes some careful work to get the pieces I need.




Once these pieces are cut I can finish the salvage operation. The pieces are tightly located so I can glue them all at once.


I also have one case where I miss the size of the blank I am cutting and the cuts are shifted slightly off the edge of the part. Another part for the scrap pile. I don’t have any pics of that mess.