Craftisian

Shin

447 posts and 14 followers
in almost 10 years
0
3

Ramblings from a South Central Texas Wood Butcher #11: The Runs

1223
3

This is part 11 in a 29 part series: Ramblings from a South Central Texas Wood Butcher

The runs, everyone gets them, or will get them. Don’t you hate them? You do everything to keep from getting them, but . . . . .

Brush or spray that one coat a little too heavy, and “Dang It!”

Luckily, runs are easier to deal with than unexpected gouges, nicks, dents, etc. With runs, you just let the finish set up, at least my clear coats, sand them out, then finish spraying, more carefully. :-)

Wishing everybody run-less finishes!

Happy Wooding!

Keith "Shin" Schindler

3 Comments

Jeff Vandenberg commented over 9 years ago

Lol I was wondering why you would be talking about personal stuff but you changed the subject. Lol

Jeff Vandenberg aka "Woodsconsin"

Wheaties - Bruce A Wheatcroft ( BAW Woodworking) commented over 9 years ago

your idea is a good one , it works . Jeff – in your case you just have to sit it out !

Wheaties

Steve Tow commented over 9 years ago

You can also take a double edged (or a single) wrap masking tape around both egdes, slightly wider than the run, and
use it like a draw knife! I’ve used it for years. It minimizes sanding.
Also there is a Run Razor, made by
Motor Guard company, which is, essentially, a razor blade plane.
they are around 8 bucks.
it’s always best to do it in the fist few hours after you discover the run, before
the paint locks up, the same with sanding it out. After you plane it down use 1000
grit sand paper to minimize sand scratches, then again before the finish thoroughly sets up you can get by with dusting a light coat on.
Poly might be the only exception, but you
can even that out with the razor!

Steve Tow

More from Shin

Ramblings from a South Central Texas Wood Butcher #29: Hot in South Central Texas, but Making Some Sawdust and Shavings Ramblings from a South Central Texas Wood Butcher #28: Soggy South Central Texas, but Making Shavings and Writing Again Ramblings from a South Central Texas Wood Butcher #27: Soggy South Central Texas, but Making Shavings and Writing Again Ramblings from a South Central Texas Wood Butcher #26: Back in the "Wood Shop," Puzzled and Swinging Ramblings from a South Central Texas Wood Butcher #25: Whoot, Whoot! Back to making chips, shavings, and Dust!
RSS