chair

Except not "finished."  I should say, it's functional. I did the test lacing with the chair on the floor.  That was a bit hard on my back.  I got ...
On the heels of completing a second deck chair based on Wegner's GE-375 from pressure-treated decking, I still had some scraps left over.  Enough f...
Well, finished without finish, but structurally complete.  Here's the completed chair next to the deck skirting from whence it came. [20221016-1G6X...
With all the last minute shaping and sanding complete, everything was ready for the final glue-up.  There's not really a whole lot to show here.  I...
(Originally posted in October 2022) In the summer of 2022, I started a project to replace the skirting around the perimeter of my deck using 5/4 p...
[Note: I am in a process of moving from Lumberjocks, this a blog series I started in 2014] This blog describes the long process of designing and ma...
With the mortises complete, I put a 1/8" edge round-over on most of the parts and sanded them all smooth.  It's easier to get this done prior to as...
Most of the pressure-treated scraps from my deck skirting project were pretty narrow - around 1-1/8" wide.  Most of the blanks needed for the chair...
This step is out of order compared to the actual sequence of the build, but it seemed to make sense to present it now.  The back receives a set of ...
As with the other replica chairs I've made, it requires spending quite a bit of time looking at example photos from different angles in order to ma...
Simultaneously aligning all 4 components of a side assembly gave me fits.  Very slight errors in length and/or angles meant that as I sequentially ...
My last pair of blanks are for the armrests.  I started by planing them down to 5/8" thick, which is the final thickness for rear of the armrest.  ...