Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Shiro Campos
67 posts
and
5 followers
in over 4 years
in over 4 years
More from Shiro Campos
3D Walnut RAM Logo
Finally messing around with 3D relief carvings. This was my first attempt and I’m hooked. Looking forward to making more but the only thing is that they take forever to carve. (Depending on your settings and bits) This one has a few flaws, but I fixed it in case I make any more of these.
Dimensions: 4” x 4” x 0.60”D
Dimensions: 4” x 4” x 0.60”D
J&S Wood Co
5 Comments
Nicely done! Can you document your process a little? Do you lay it out and make primary cuts then go back and refine it or…? I’ve never done that before and I’d be interested to understand your methods.
Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".
I'd like to know about how much work you put in after the carving. I always assumes there would be a bunch of sanding to remove the milling marks. This carving looks quite smooth. Nice!
I can see this being a hot item with Dodge truck guys, maybe plop the rams head into a coin tray, phone carrier type thing. Just musing....
Nice job, if it's your first work, you are a talent.
Nice job, if it's your first work, you are a talent.
That is seriously cool!
very cool shiro !
working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.
More from Shiro Campos
