Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
majuvla
662 posts
and
24 followers
in almost 2 years
in almost 2 years
More from majuvla
WALLHANGER
160x18x2 cm beech segment wallhanger. I cut two dimensions slats on mitersaw : 7x18cm and 3x18cm. Narrow slat has two angle cuts on ends : 45 (upper) and 60 (bottom) degree.
On drillpress I made 10mm holes, 35mm from slat end. I used 10mm threaded metal rod and two nuts on ends to assembly all.
I used ''French cleat'' principle to mount it on the wall, with two 160x5cm firwood slats, with 4 wall mount points.
Finish wood oil.
On drillpress I made 10mm holes, 35mm from slat end. I used 10mm threaded metal rod and two nuts on ends to assembly all.
I used ''French cleat'' principle to mount it on the wall, with two 160x5cm firwood slats, with 4 wall mount points.
Finish wood oil.
...woodicted
8 Comments
Bravo!!
You don't always get what you go after,but you do get what you wouldn't have got if you didn't go after what you didn't get. Blaze Foley
Like the sign as well as the rack
Ron
great simple hanger. i like that sign too.
working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.
Nicely done!
Nicely done!
Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".
GR8 JOB 😍😎👍
*TONY ** Reinholds* ALWAYS REMEMBER TO HAVE FUN
I like your hanger design. Is the wood clear fir?
daveg, SW Washington & AZ
Gdaveg, dont understand your question...it is beech not firwood
...woodicted
More from majuvla
