Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Birdseye49
515 posts
and
13 followers
in about 2 years
in about 2 years
More from Birdseye49
Laser Christmas Card
This is my attempt to make a wood Christmas Card. I used 1.5 mm plywood and dyed wood on my Ortur LM3. I am just really learning to use Light burn and this was a learning project for me.
8 Comments
nice birds !
working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.
Looks good! What are the general dimensions?
Nicely done!
Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".
I used 1.5 mm plywood and dyed wood
Are they inlays or just a very steady hand?
If your first cut is too short... Take the second cut from the longer end... LBD
It is 4" x 6" and with1.5 mm inlay dyed wood.
I should have been more direct... did you cut the inlay (and the inlay's void) by laser?
If your first cut is too short... Take the second cut from the longer end... LBD
Looks like you are getting the fitting down great BE!
Cool thing is the card and any to/from stuff can be sanded off and reused!
It can be a challenge working out the kerf offsets. Currently I'm trying to imitate some Harvey Ellis inlays and it can be a real pain with the micro sized bits.
Cool thing is the card and any to/from stuff can be sanded off and reused!
It can be a challenge working out the kerf offsets. Currently I'm trying to imitate some Harvey Ellis inlays and it can be a real pain with the micro sized bits.
Looks good to me buddy. I can easily read it, has that hand made look down pat, and it is definitely a Christmas card.
Wishing you, and yours a very safe, and merry Christmas, and a wonderful New Year.
Wishing you, and yours a very safe, and merry Christmas, and a wonderful New Year.
More from Birdseye49
