This is another toy for the animals at the zoo. They push this log around and treats fall out of the 4 1" holes I put in it. I didn't get the real plan until I had the pockets milled on both halves. The original photo showed a pocket on both sides so that is what I went with. I milled one of the pockets extra deep.
It is an 8" hard maple log- 20" long- that is split in two and then the insides were flattened on the mill with a 3" fly cutter and the pockets were milled in for the treats.That long V block I made a couple weeks ago worked just perfect for holding it. I was going to clamp it to the V block but could not finish the top surface so I mounted it with 8 screws in from the bottom.
I drilled and counter bored two holes for the bolts that hold it together. I used 1/2-13 threaded rod with the nut and washer brazed on one end. I also put in 2 3/8" stainless steel dowel pins to hold the alignment during assembly and when it gets knocked around.
I added some process photos below:
This wood is so green that it does not cut clean at all!!!!!!!!!!
Cheers, Jim
.