The box the kit came in was a cardboard box that was in poor shape. Decided a storage box was needed.
Design was decided over the following limitations. 1. Scrap wood in the shop, this case Butternut. 2. Use the foam tool holder from the original cardboard box. 3. Use any existing hardware.
With the size of the foam deciding the interior size the box became. 14-1/2" x 7-7/8". Height of box determined by pieces of Butternut long enough to make the sides,,,thus 3-1/2". Side thickness 1/2". Top, bottom and tray bottom from 1/8" thick pieces of Butternut
Tray size became 13-1/2" x 6-3/4" x 1-1/3". Tray wall thickness 5/16' Height of tray limited to interior height of box.
3/8" box joints on the box and tray. Joints cut on router table using old Incra Jig. (jig is over 25 yrs old. been very good) Box and tray glued with Titebond Original. Finish is 3 coats of wipe on poly gloss. Had just enough of the poly for this project. Mortise for hinges hand cut with chisel. Butternut is easy to cut.
The Tensioner that came with the kit is quite heavy, metal, and easy to use. Cinches tight and cuts off the SS ties easily.