As one gets older the skin is more subject to bruises and cuts. The ends of the Woodpeckers mitre fence on the table saw and the one on the Incra Ultra fence have inflected both bruises and skin cuts on several occasions. Walking by hand hits the protruding fence end. Always when neither are actually being used and mainly due to me being less that careful as I pass by. How to help eliminate this happening.
Simple wood caps made of Poplar sanded smooth with all corners and edges rounded. Now a bruise is still possible but the soft wood vs the aluminum fence with corners is a step towards a hand or wrist without DNA leaks.
The cap fence on the Woodpeckers is 3" tall, 1 3/4" wide and 2 1/4" deep with the hole for the fence to fit in 2 1/4" high x 3/4" wide and 1 7/8" deep.
The caps (2) for the Incra Ultra Jig fence is 4" tall, 1 3/4" wide and 2 1/2" deep. The hole for the fence is 3 1/16" high, 7/8" wide and 2" deep.
The really only critical dimensions are the ones of the hole for the fence to easily side into. A bit of 1/8" diameter bungee cord is used to hold the cap or caps in place. The stretch of the bungee makes the caps easy to remove when the fence is to be used. Used some staples to hold the cord in place when taken off the tool. Painted red as that was the only bright colored paint on hand.
Explored other possibilities for securing the caps in place and of cap material. This might be a good project for 3D printing.
Now to hopefully have healthy hands and wrists.