rfprice62

This small mill has two doors. This is done so the housing is accessible even when the wings of the mill are turning in front of the door. [Image] ...

This mill has a concrete base and brick stone walls. According to annotations on the drawing the mill wasn't built like this. It had a stone founda...

The Water that is pumped by the mill has a exit called "waterloop". It houses a door to keep the water on the high side of the mill out (like a hor...

The "Stoelbalk" and the "wervel" are the parts on which the main spindle rests. The wervel is made so it can be moved to fine tune the running of t...

The screw's main baring is what's next on the to-do list. [Image] In the real world the main baring is usually made of stone, But occasionally it...

The lower part of this mill is cladded in wood. I want the cladding to be removable so i can access the inner works and also to be able to show wha...

[Image] To prevent the mill from blowing over it is anchored to the concrete foundations. In my model i'm not using any concrete and this windmil...

This time a simple part: the main spindle of the mill [Image] Just a square piece of oak [Image] Adding some stopped chamfers [Image] Using a...

Next on my worklist is the "schroefbak". It's the part where the screw is placed in. On the drawing this is made of concrete. [Image] The mill is...

Last part was a very simple part. Now lets make the most difficult and challenging part of this mill: the "schroef" or "vijzel". A Archimedes screw...

To prevent debris from getting into the screw, there is a weed and trash screen in front of the screw. [Image] There's also some sheet pile to pr...

On the drawing there is a small bit showing how the mill is situated [Image] So i will try to recreated that. First by laying it out on a sheet o...