WIth the blocks assembled, time to move on to the end caps. There will be one for the top side of the lower block and top/bottom for the middle blo...
orStarting here since these form the basis of it all. I want this column to be all finished before making the lamp base. There are target dimension...
Some time back I made a floor lamp project and at the time I also made two shades since it is easier to knock a few out versus just singles with al...
So it has been a while! For a while now I've been using a free, on-line software called ImageR for getting settings near perfect for etching onto ...
I've done a previous blog on a similar item, but this time I'm including the design process for those of you who are interested. Making another pa...
Apologies to the Doors! [IMG_0165.jpeg] Finally the finish has been sprayed. Base coat is Mohawk vinyl sealer, top coat satin pre-cat lacquer. Pr...
[IMG_9043.jpeg] Best laid plans..... Anyhoo, busy weekend with car work so I couldn't get as far as intended (finish applied), but wait, there's m...
Ok. Here is the primary reason I'm building these side tables. Plans were to keep the tables stupid-simple to avoid any drama. I violated my goal ...
Finally. Got the wood prep all done 🤠 Table tops came out of the clamps aok, no drama or glue blobs to deal with thanks to the extensive taping. [...
[IMG_9010.jpeg] With the legs mortised for the bottom cross brace, the top cross brace needs to be dealt with. Doing the ol' dovetail half lap bo...
I decided that I wanted to roll the dice and see if I could escape fate. Through tennons! 😱 Plenty of opportunity to really screw up, me like! L...
So, Same process for the legs, I'll skip by fast. Trim the excess, leaving about 1/16".... [IMG_8988.jpeg] ... for the router with a flush trim bi...