3D Crosses

7
1
I just completed a set of nine crosses. There is a build blog covering the design and construction. The short version is there is a good deal of CAD and CNC work involved as well as woodworking.
 
I’ll give the details of each cross here. They are shown in build order. First up is a 14 inch tall cross. The center veneer is curly maple. The surrounding frame is tiger wood (according to my lumber store). This is the first one I built and I tweaked a few features to help with the assembly.


The next one is a 14 inch tall cross with a bird’s eye veneer center and a red balau. Being the second one I did find a few details to tweak.


The third one is a 14 inch tall cross. The center veneer is curly maple with a red balau frame.


The fourth and final 14 inch tall cross has the added feature of a perimeter line. The center veneer is bird’s eye maple. The frame is tiger wood and the perimeter strip is red balau. Red balau does not steam bend well and straight grain pieces are required.


The next 5 crosses are all 12 inches tall. This means all new CAD and CNC files are created. The 5th cross has a lacewood center veneer, a walnut frame and an ash perimeter strip. Ash steams bend easily and is a good choice for the tighter bends in this smaller cross. This is the cross that required the repair effort in the “Confession” chapter of the blog.


The 6th cross is 12 inches tall. It has a spalted maple center veneer and a walnut frame. This maple came from a tree that went down in our back yard.


The 7th cross is much like the 6th one. The frame is red balau instead of walnut.


The 8th cross is a 12 inch tall cross with bird’s eye maple center veneer. The frame is tiger wood.


And finally, the 9th cross is the same as cross #5. No major repair on this one.


I have about 180 hours into this project. I enjoyed the challenge of learning how to put my CNC to work creating the 3D shapes. If I make more I’m sure it will take less time. 

These were taken to a craft fair at my church. Everyone liked them and more than half were picked up. 
dude all are awesome ! i wish i had your talent with the tech. i just dont and never will so i do everything the old way, by hand !

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.