Craftisian
0
0

Casket # 1

1498
3
Casket # 1
Casket # 1 Casket # 1 Casket # 1

I finally figured out the 2 angle for the compound cut , I assembled the lower half of the top . The one picture is a corner , best I can get it . The last picture is the upper part of the top being added .I used 6 " oak cove molding that I buy for a dollar a running ft . 10 ft = $10.00.

Wheaties

oak sliding compound saw nail gun glue clamps oak

3 Comments

James L Wilcox commented about 9 years ago

Viewing this in reverse, now I see how you got to the finished top. Very nicely done.

Jamesw

lanwater commented about 9 years ago

That’s a lot of molding you aligned and perfect too.

Well done!

Abbas, Castro Valley, CA

a1jim commented about 9 years ago

Creative approach for sure

woodworking classes, custom furniture maker

More from Wheaties - Bruce A Wheatcroft ( BAW Woodworking)

Casket # 3 - Project by Wheaties - Bruce A Wheatcroft ( BAW Woodworking) Casket #2 - Project by Wheaties - Bruce A Wheatcroft ( BAW Woodworking) Wood verses particle board - Project by Wheaties - Bruce A Wheatcroft ( BAW Woodworking) the beginning of a sectional bowl - Project by Wheaties - Bruce A Wheatcroft ( BAW Woodworking)