Journey into Hexagon Boxes

I wanted to make some hexagon boxes again, this time using thinner stock. Started out with some rough cut 4/4 Pecan and Maple about 8" wide and 8' ...

Finished fitting the drawer panels and glued up the drawers. [20230303_115133.jpg] [20230303_121802.jpg] Sanded the proud fingers on the disk s...

Moving along to the top and bottom, had to surface a edge join a couple of pieces, to glue up for the width I needed. Used the Moxon bench top with...

Been a little slow on progress, yard work has been getting in the way. Had a few of the finger joints that were a bit off, so with chisel in hand,...

Back at it again, I finished the inside of the case along with the interior surfaces of the top and bottom. I taped off the edge where the glue li...