chair

After finishing my stick chair almost a month ago, I finally got the video done for it. They were both a lot of work! [2025-08-31_07-12-42.jpg]...
I was out of town for a few weeks, and wasn't able to be in the workshop.   But I was able to brush up on my Fusion skills and start modeling the f...
For cutting the yoke tenons, I used the technique described by Ty earlier, rather than using a filler piece in the top curve of the yoke.  Ultimate...
Back when I was flush-trimming the arm and seat rail components, I avoided routing the straight edge on each where they would eventually be joined....
A few installments back, I shared my hope that I would be able to weave the backrest assembly and seat/arm assembly independently and then connect ...
As mentioned earlier, the armrest will fit into a 1/8" deep recess on the top of the arm.  I made this router jig (from scraps) to use to cut the r...
There were a couple things I wanted to verify before the final glue-up: • Could I keep the paracord lacing tight enough so that it would support a ...
While I had been thinking about how to make the arms from the time I had started scheming to build this chair, by the time I got to this point, I s...
With all the major shaping and sanding completed, I had one last task before glue-up, and that was to pre-drill the seat frame for all the L-nails....
Time to put the new jig to work for the backrest stile mortises.  I started by transferring the centerline for each of the three rails from the sti...
With the router jigs for the side assemblies completed, I could get to work cutting some mortises.     Cutting the mortise for the lower rear stre...
To cut the mortises for the stretchers (front/rear lower stretchers and upper rear stretcher), I needed a couple more jigs.  In these, I used a com...