Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
MikeB_UK
1865 posts
and
24 followers
in about 2 years
in about 2 years
More from MikeB_UK
Rounding Plane
Needed a 1 1/4 inch rod for a vice screw, so made a rounding plane.
Usual rambling picture blog here
Seemed to go wrong more than right while I was making it, but turned out OK.
Hand tool build only, feel free to comment/criticise as always.
Usual rambling picture blog here
Seemed to go wrong more than right while I was making it, but turned out OK.
Hand tool build only, feel free to comment/criticise as always.
10 Comments
We make the tools as the need arises. A good-looking plane, and a nice write up.
Main Street to the Mountains
Thanks Eric
Nice tool you made, 👍 👍
Nicely done!
Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".
Thanks Tom & Ryan
You don't hold back!
Make a tool to make a tool part used in a tool to be mounted on a tool.
Make a tool to make a tool part used in a tool to be mounted on a tool.
That is a mouth full of tool items.
Main Street to the Mountains
That looks pretty high tech, nice job it looks difficult to make but it worked well.
.................. John D....................
Cheers splint, it's possible that I'm just easily sidetracked, I could have just planed it down to close enough for the tap - but who doesn't want a new tool? :)
Thanks awsum, Low tech not high tech ;)
Thanks awsum, Low tech not high tech ;)
MikeB_UK
....
Thanks awsum, Low tech not high tech ;)
It's not the tech, as long as it works... The trial and error raises the degree of difficulty.
After all, the F1 car probably started with a nut!
If your first cut is too short... Take the second cut from the longer end... LBD
More from MikeB_UK
