Pen Display Board

238
9
I needed a board to display the more expensive pens at shows.  I have a revolving rack for the Slimlines but did not want to put these in with them. I guess I'll need to made a few more to fill this board. I made 7 slots ( the perfect number!!)

It is made from 5/8 Baltic birch plywood, stained with special walnut stain and finished with clear satin enamel.

Cheers,, Jim

Cheers, Jim ........................ Variety is the spice of life...............Learn something new every day

looks good jim. if you do well your gonna need one a "lot" bigger ?

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

Looks great!

Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".

Nice! But if they are "premium" pens maybe it ought to have a lock on it?

The Other Steven


Can't fault this.

If your first cut is too short... Take the second cut from the longer end... LBD

Nice ''place'' to keep them safe and countable.

...woodicted

Thank you all for the nice comments. I was just goofing around and thought I might need this in the fall!!

Cheers, Jim ........................ Variety is the spice of life...............Learn something new every day

Jim,

Nice pen holder.  Did you use the mill to cut pen slots?

Looks Great!

daveg, SW Washington & AZ

Thanks, Dave. Yes I used a ball end router bit in the mill to make the slots. I use HNC ( Human Numerical Control) machining! I cut one, record the numbers and make all the rest of the slots using those numbers  for stops! I have a table   with T slots for the vice that I made many years ago and it makes it so easy to set up a job like this !

Cheers, Jim ........................ Variety is the spice of life...............Learn something new every day