RobsCastle

in the beginning

this blog has been a few days to completion mainly due to too hot outside or other Higher priority tasks overtaking it I carved all the drawer fro...

I haven't done too much actual work but made some progress. [IMG_0188.JPG] I have this 3D carver so i brushed off the dust and set it up to do carv...

Hello again! Upon having all the drawers completed apart from the fronts it was time to decide on a design I toyed with the idea of having beaded e...

There is a lot of down time during these days so its not representative of the actual task duration but cannot be avoided. The drawer construction ...

[IMG_0089.JPG] I screwed the frame together and started making the slide supports. I have a stash of recycled slides but they were too short and I ...

 I have part of the Kreg Beaded Face Frame Jig (BFF), Minus the actual Jig. Just a beading bit and a notching bit. They are a fascinating way of le...

I managed to get all the plugs cut for the top side of the Table Top. Plug cutting:- By way of an explanation and to provide how this was done with...

Here is the progress so far:- 1. Routed the edge and rounded it over. I used a straight bit with a top bearing deep enough to do the job. The rou...

Could be somebody we all know is having a birthday tomorrow 7 Apr 2018 James Bonds Car is the clue ! …(again) … I couldnt think of a another one ju...

Another part day getting the Panel Door to a completed dry assembly stage. It began with an overnight glue up of the panels, but first up a bit on ...

Well almost a day, it was so windy here AM I thought somebody had redirected Irma my way. A very sad state of affairs in Florida and surrounding da...