RobsCastle

In Apr 2020 I was given a Hare and Forbes 12" Table Saw from The Christian Brothers High School in Lewisham Sydney NSW. [CBHS 12 inch Table Saw ST...

I am trying to make a coffee table for my sister But Kreg seems to have pulled a swiftie I have a Kreg and have had it for sometime However have a ...

At long last the cigar boxes are finally finished. [Usain Bolt 2.jpg] The Lids Assembly The BIC spring loaded hinge pivot points were assembled [IM...

The lids The lids use a bamboo dowels as pivot pins, how this is achieved is with internal springs  behind each of the dowels. The dowels are simpl...

Excuse the mess trying to learn how to add parts to an existing blog! Hinging lids on thin material The Hinged lid After discarding the brass hinge...

The Cigar boxes continue, ... ignoring my inner self saying toss them in!  The box frames are made and now raw finished. Original Intent 5 x Cigar...

 had quite a lot of off cuts from my Inglass pallet work accumulating [Image] So I decided i would do a "quick" Cigar box build using them As this...

The Cigar boxes continue, ... ignoring my inner self saying toss them in!  The box frames are made and now raw finished. Original Intent 5 x Cigar...

I had quite a lot of off cuts from my Inglass pallet work accumulating [inglass small off cuts.JPG] So I decided i would do a "quick" Cigar box bu...

I logged in today and was surprised to see Bob Puttman shown in Members Spotlight [Grizzman.png] A bit of an Opps to say the least. Martin/Debbie ...

I was driving along and spied this B&D Workmate sitting in the council clean up pile. I just  did a big smoky U turn and returned to confirm it was...

Back in 2019 I was helping a friend extend a house and he needed a hand with the trusses we had about 8 trusses to fit to extend the roof line. how...