Mini Office Workbench #10: Threading, bolting and rubberising the cookies

400
0

This is part 10 in a 13 part series: Mini Office Workbench

  1. Introduction
...
  1. Sanding the cookies
  2. Threading, bolting and rubberising the cookies
  3. Drill the side clamp holes, finish cookies
...
  1. Epilog 

Boys and Girls,
                                                                                                     
Chose to cannibalise some threaded rod,
using my cordless bandsaw,
 
With the Wood Whisperer’s threader the cookies got screwed,

and the thread was tested,

cookie position marked,
(running out of commentary after 9 episodes)… 
 
The mark was centre punched using my Veritas gizmo,
 
The bolt was epoxied in the thread and the rubber matting “under” the cookie,
 
 Just a tad more detail has been presented in this video,


 

If your first cut is too short... Take the second cut from the longer end... LBD