Craftisian

Dutchy

1057 posts and 53 followers
in over 9 years
0
4

Wheels #3: Continuation

1195
4

This is part 3 in a 6 part series: Wheels

  1. Take-off
  1. Jig
  2. Continuation
  3. Tyre
...
  1. Rims part 2

In this blog you can see how I made a cove profile on my small router table. Also made the grooves in the wheels on my table saw.

Below you can see how I did it:

Making the grooves

Thanks for watching.

https://dutchypatterns.com/

4 Comments

Wheaties - Bruce A Wheatcroft ( BAW Woodworking) commented over 8 years ago

That was an excellent idea , I like the tightening knob , just rotate till the mark lines up , tighten it up and make your pass .

Wheaties

Dutchy commented over 8 years ago

Bruce I reveal you a secret. Between the knob and part D I have two washers and two spring washers. When the wheel is mounted I can rotate the wheel till the mark lines without loosen it. There is tension enough to do this

https://dutchypatterns.com/

Wheaties - Bruce A Wheatcroft ( BAW Woodworking) commented over 8 years ago

That is really a good idea . You have some impressive skills .

Wheaties

Mike40 commented over 8 years ago

Engineering as much as woodworking. Great jig!

Mike, an American living in Norway

More from Dutchy

VW BULLY T1 Camper van #20: VW Bulli T1, Pack rack VW BULLY T1 Camper van #19: VW Bulli T1, Roof VW BULLY T1 Camper van #18: VW Bulli T1, Wheels VW BULLY T1 Camper van #17: VW Bulli T1, Bumpers VW BULLY T1 Camper van #16: VW Bulli T1, Front window parts
RSS