Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
RobsCastle
1210 posts
and
24 followers
in over 10 years
in over 10 years
Indian Pallet timber Credenza #2: Making drawer fronts Cutting carving profiles and making a door joint
This is
part 2
in a
2 part
series:
Indian Pallet timber Credenza
-
Introduction
-
Making drawer fronts Cutting carving profiles and making a door joint
- Introduction
- Making drawer fronts Cutting carving profiles and making a door joint
The two drawer fronts were biscuit ed "0" and glued together and put aside
fairly straight forward
then into the clamps
Next was the saw profiling of carving
The frame will be pocket hole and glued once I am OK for it to be assembled
Here are the 5 fixed uprights
Next come the joint method for assembling the three doors with my Tenoning Jig I produced this proto type.
It didnt take too long
It should work OK.
its a pity my finger joint kit is only 8" it would have eaten this.
A job for tomorrow
fairly straight forward
then into the clamps
Next was the saw profiling of carving
The frame will be pocket hole and glued once I am OK for it to be assembled
Here are the 5 fixed uprights
Next come the joint method for assembling the three doors with my Tenoning Jig I produced this proto type.
It didnt take too long
It should work OK.
its a pity my finger joint kit is only 8" it would have eaten this.
A job for tomorrow
Regards Rob
