The face frame
The face frame for the credenza continues, a bit of a setback dimension wise as I realised after assembling every thing the Left and right sides of the frame were the incorrect size.
So I had to re do the frame to reflect the correct 90 mm ones.

As a result this threw out my dimensions 50 mm.
I now had the decision to make as to how I could manage it.
1. Reduce the 3 uprights  or,
2. Reduce the door and drawer width
Reducing the upright dividers meant ruining the semi diamond pattern, so that was discarded.
So I reduced the door and drawer width from 400 mm to 380 mm and extend the frame out  a further 10mm of which it could just accommodate, so it happened.

I recut the story sticks to 380 mm and commenced finalising the frame.
I used pocket holes and glue to secure everything

However at the final piece there was a miss match between the top and bottom rails
The top was over length, so it was no big deal.

However there was a shortfall on the bottom.
So after running a framing square over everything I found no errors  so I had to add a section on the bottom frame.

I set it aside to dry and commenced the door frames.
The three door frames
I used my tenoning jig to cut the M&T/lap joints

all went well there

and completed the task

I didnt rip the door frames down from 400mm as I could do it at final assembly.

The inserts will remain the same dimension

Nail Holes
I then plug cut inserts for all the nail holes

Worked my way around the frame.

The Drawers and doors are next
To be continued