More from Jeff Vandenberg

Part 3 of table repair is on YouTube New shop toys New Video has been posted on Youtube Mag Switch Re-saw Fence Member of the Week

RSS

Workbench / Outfeed Table #1 #4: getting further

1704 views

5 comments

This is part 4 in a 11 part series: Workbench / Outfeed Table #1

Workbench/ Outfeed

...

Continued Build of Workbench

getting further

Workbench/ Outfeed continued

...

wheels go round and round

View all parts »

Well im making some head way. I did the reinforcement on the bottom beams because of inertia. I have the face frames done, & one on now. I did some edge banding today on a piece for my french cleat section. We’ll see what the weekend brings.

Jeff Vandenberg aka "Woodsconsin"

workshop benches workbench workbench tops outfeed table workshop storage

5 Comments

Follow comments

lanwater commented almost 10 years ago

It’s coming along nicely Jeff.

Abbas, Castro Valley, CA

Thorreain commented almost 10 years ago

Yes, ditto.

CHRIS, Charlottetown PEI Canada. Anytime you can repurpose, reuse, or recycle, everyone wins!

Steve66 commented almost 10 years ago

That’s looks nice Jeff!

steve66

Jeff Vandenberg commented almost 10 years ago

Thanks guys really appreciate it. I’ll tell you this is a challenge more so for the reason of spanning without deflection. I had a plan in my head and wrote down what I wanted however, I changed it three times as I went. Well I just sat down and calculated the weight of my to stretcher beams now that I built them up. I follow the formula of “IF”. "IF is the “inertia” of a member when used with the Modulus of Elasticity of the particular material allows us to predict the deformation (deflection) of that member when loaded.If = (width)(depth)(depth)(depth)/(12)…in inches to the fourth power!
All said and done I get 31 lbs per square inch times 540 square inches = 16,740 lbs so I think im good. Lmao!!! Not getting and deflection now.

Jeff Vandenberg aka "Woodsconsin"